Owatrol NET-TROL cleaning gel, degreasing wood

OWATROL NET-TROL Gel de-greasing preparation, restoring color and neutralizing after using Dilunett, Aquanett, Prepdeck and CDKP 90. For use on external surfaces of softwood, including pressure treated, hardwood and heat treated, and other materials such as like stone, cement and plastic. Perfectly removes the gray, blackened color left over from UV rays and various weather conditions. Recommended for stains caused by tannins (tannins), and additionally very well degreases the elements before applying the final, target layer, e.g. oil, varnish, paint or stain. It is an effective agent for removing stains from rust, as well as cleaning stains caused by fungi and mold. It is a safe, ecological agent that can be washed off with water after use.

PROPERTIES:

• For outdoor use only
• By removing blackened discoloration, it does NOT damage the wood fibers
• Natural wood effect in 15 minutes
• Indifferent to plants and shrubs
• No bleach or solvents in the composition
• Thoroughly removes the greasy film of tropical wood before final painting, eg DEKS OLJE D.1
• Examples of wood species: hard - oak, walnut, ipe, iroko
• soft - cedar, spruce, larch
• Removes and neutralises tannin stains
• Cleans mold and mycelium spots
• Gives shine to plastic elements in dull, darkened weather conditions.

IMPORTANT:

• DO NOT paint ALUMINUM parts
• To prevent the agent from drying out too quickly - do not paint over heated surfaces
• Water the vegetation within the working radius abundantly
• Start painting the vertical places from the lower parts and upwards
• Flat places in the middle of NET-TROL, e.g. terraces, platforms are slippery, so use warning signs
• NET-TROL left for more than 20 minutes will tarnish metal parts. Rinse immediately with plenty of water or collect with a wet cloth

HOW TO USE:

Before application, the places selected for the application of NET-TROL should be washed off with water and sanded. Stir well before opening the container and shaking it properly before use. Elements not covered by the works should be tightly secured.

Wooden, stone and concrete surfaces

Soak with clean water without flooding the selected surface. We spread NET-TROL with a synthetic roller or a nylon brush with long or medium bristles. Apply with a scrubbing motion or scrub with a stiff nylon brush. We leave it for 10 to 20 minutes. Do not allow the surface to dry out, then spray the water. After the time has elapsed, scrape with a stream of water or with a high-pressure cleaner - with a stream of max. 60 bar. Repeat if necessary.

Plastic and fiberglass surfaces

Rust stains

Moisten the target place with clean water and apply NET-TROL using a brush. Then we wait 10 minutes. Scrub the surface to be cleaned with a soft or medium hard brush. Rinse thoroughly with plenty of water

DRYING TIME:

Wood - 48 hours - humidity must be adjusted to the chosen final layer.

Stone / concrete - until dry - and humidity suitable for the end layers

COVERAGE: 5-10 m2 / l, actual efficiency depends on the condition and type of surface.

TEMPERATURE: Use between 5 ° C and 35 ° C

TOOLS CLEANING: soap and water