Owatrol DILUNETT gel for removing old coatings

DILUNETT It is a solvent-free gel that removes old paint coatings based on phthalic and alkyd paints / varnishes. The agent is non-flammable, paraffin-free and does not evaporate, but general safety rules should always be followed. It can be applied on flat surfaces, and thanks to the consistency of the gel, it does not dry out and run off, making it easier to work on vertical surfaces. The advantage of the DILUNETT gel formula is the possibility of extended operation time on the surface by removing up to 8 older coatings. Recommended for use on any type of wood except oak, chestnut, walnut and cedar. On other materials, it will very well remove surface layers from metal, cement, stone and PVC elements without damaging the plastic. Do not apply to aluminium parts

PROPERTIES:

• Hazard-free - VOC-free, non-flammable
• No poisonous fumes
• It does not require mechanical operation
• Can be used at higher temperatures
• Gel consistency
• Strong - removes up to 8 older coatings
• It violates the layers by dissolving them
• Easy to apply
• With the help of water, you can reactivate the measure
• It does not damage the surface, therefore it is widely used
• It will not work on two-component paints and sintered paints

Before use We recommend that you make the test in an inconspicuous place. Get rid of flaking fragments of paints, stains or varnishes and clean them from dirt, and flat workplaces should be descended. In order not to cause greying of the wood, the reaction time for DILUNETT should not be exceeded

HOW TO USE:

• We apply in thick layers over the entire target surface. We leave.
• The agent is active for 5 minutes. up to 12 hours
• For better efficiency, do not exceed the operating time - the original surface may turn Gray
• After the indicated time has elapsed, rinse abundantly with water, a cloth or a pressure washer up to 60 bar
• The use of warm water will facilitate rinsing
• We always neutralize with NET-TROL, especially when the surface is not smooth and porous
• The maximum duration of DILUNETT activity on pavements is from 10 to 45 minutes.
• EFFICIENCY: 4 m² / l actual consumption depends on the condition, species, type of surface, and mainly the number of layers to be removed
• NEUTRALIZATION: Always use NET-TROL
• TEMPERATURE: Use between 5 ° C and 35 ° C.
• TOOLS: brush with synthetic bristles, putty knife, high pressure washer.
• DO NOT store in metal containers
• TOOLS WASH: water