Owatrol Compo Clean cleaning agent for composites

Compo Clean cleaning agent for composites

COMPO - CLEAN for composite boards is a product designed to clean and restore the natural appearance of composite surfaces. It is a water-based agent, completely safe for the environment, and because it does not contain paraffins and solvents, it does not react with glass, plastic or stone.

It is very good at eliminating all kinds of greasy stains, but also moss growth and post-season dirt. It can easily deal with surface contamination that is fresh, topcoat and older that have already penetrated the structure of the composite. It does not require dilution and is ready to use. The gel consistency makes it easier to work on vertical surfaces because it does not drip.

PROPERTIES

• For outdoor use
• For composite surfaces
• Yellowish orange final color
• Gel formula, ready to apply
• Not harmful to the environment
• For vertical and horizontal surfaces, e.g. garden architecture, terraces, surrounding pedestrian routes, facades
• Dedicated to smooth and grooved composites
• It gives off a slightly perceptible smell

Before use:

• The selected places should be dry, and the footpaths free of sand and even dust
• Shake well before opening
• Secure the area around the works and adjacent places
• If there are plants in the vicinity of the painting, water it with plenty of water
• In one designated section, the work should be continuous for a uniform effect
• If there is mold or fungus, scrub with a solution of water with household bleach in a ratio of 1: 1, leave for 10-15 minutes - rinse thoroughly, then wait until it dries to the level of min. 18% humidity
• The places where the product will be applied must not be heated
• Paint vertical parts from bottom to top
• Composite cleaning agent application:
• COMPO-CLEAN - apply a fairly thick layer - leaving it for a minimum of 5 minutes, can be extended for more difficult dirt
• After the COMPO-CLEAN operation time has elapsed - remove with a hard synthetic brush
• We rinse with plenty of water under pressure up to 50 bar
• When planning work, it is important that after application for at least 2 days, they must be dry and good weather.
• We apply other planned finishing layers only after 2-3 days
• COVERAGE: from 5 to 10 m2 / l. The actual consumption depends on the type and condition of the surface and its structure

TOOLS:

• synthetic roller or synthetic brush, stiff nylon brush,
• for rinsing a garden hose or high pressure washer
• TEMPERATURE: 5 ° - 35 ° C do not apply on hot surfaces and in full sun
• WASHING TOOLS: Water